Granulator Structure Description

1. Main body: The body is an independent rectangular column. The upper bearing is connected to the powder hopper. The powder hopper extends to the outside of the machine. The V-shaped chassis is installed underneath. , Can be placed indoors at will.

2. Particle manufacturing device: The rotating drum is placed horizontally under the powder hopper. There are bearing supports at the front and back. It is reversed and rotated by the transmission of the rack. The front bearing cover at the end is movable. The next wing nut, the bearing cover and the rotating drum can be pulled out, and the two ends of the placing drum are made with convex square rings, which are embedded in the bearing chamber, so that the oil pollution will not penetrate into the powder and will not be blocked.

3. Reduction gearbox: adopts worm gear transmission, the speed ratio comes to 1:12, oil can be stored in the box to ensure good lubrication of the gears and no noise, there are sight glasses on the box to observe, observe the operation and oil storage, the outer end of the worm gear, Equipped with an eccentric shaft to drive the rack to reciprocate.