Granulator Maintenance Instructions
Leave a message
1. Check the machine parts regularly, once a month, check whether the moving parts of the worm gear, worm, bolts on the lubricating block, bearings and other parts are flexible and wear. If the defects are found, they should be repaired in time.
2. The machine should be used in a dry and clean room, and should not be used in places where the atmosphere contains acids and other gases that are corrosive to the body.
3. After the machine is used or stopped, the rotating drum should be taken out to clean and brush the remaining powder in the bucket, and then installed, ready for the next use.
4. When the roller moves back and forth during work, please adjust the M10 screw on the front bearing to the appropriate position. If the gear shaft moves, please adjust the M10 screw on the back of the bearing frame to the appropriate position, adjust the gap so that the bearing does not make noise, hand pulley, appropriate tension is appropriate, too tight or too loose can cause damage to the machine .
5. If the shutdown period is longer, the whole body of the machine must be wiped clean, and the smooth surface of the machine parts should be coated with anti-rust oil and covered with a cloth.







